Hi I have jbd 36v 10s bluetooth bms
Just a few questions I wanted to check…
OLD BMS
.Balance leads disconnect (do I just pull all balance leads out at the ribbon clip or disconnect one wire at a time from BC10 to BC0)
.then disconnect B- and C-
NEW BMS
.Connect B- and C-
.connect balance leads from BC0 to BC10
Is the above correct?
.can I connect the Bluetooth and temp probes at any time?
.this is plug and play I don’t need to connect to a p.c. ?
.I will be applying all exact same settings of old bms through xiaoxiang app, except for peak amps to be changed from 100A to 150A
.does C- wire need to cut to 15cm first as they are already 19cm?
How important is it to keep at 15cm?
.if my old bms has just one C- and one B- wire can I cut off the spare wire if so witch ones?
Thankyou for your help
